Ingredients:
1/2 tsp ground turmeric
1/2 tsp salt
2/3 mustard oil or vegetable oil
1 tbsp ground coriander seeds
1 tsp ground cumin seeds
1 1/2 tsp finely grated ginger
1 tsp ground turmeric
1/2 tsp red chilli powder
1/2 tsp salt
1/4 tsp kalonji
4 whole red chillies dried
2 bay leaves
1 large onion peeled, chopped
3 whole green chillies
How to make bengali fish fry:
- Cut the fillets in about 4cm size.
- Rub the fish well with the 1/2 tsp of turmeric and 1/2 tsp of salt and set aside for 10-15 minutes.
- Heat the oil in a non-stick frying pan over a medium flame. If you are using mustard oil, let it get smokingly hot.
- Now put in the fish pieces and brown lightly on all sides without cooking them through.
- Gently lift the fish out of the oil and put it on a plate. Turn off the heat.
- Combine the ground coriander seeds, the cumin, ginger, 1 tsp turmeric,chilli powder (cayenne pepper) and 1/2 tsp of salt in a small bowl. Add 3 tbsp of water and mix.
- Remove all but 5/6 tbsp of oil from the frying pan. Heat the frying pan over a medium flame.
- When hot, put in the nigelia seeds. A few seconds later, put in the red chillies.
- As soon as they darken a bit, put in the bay leaves. When the bay leaves start to darken, put in the onion.
- Stir and fry the onion, lowering the heat, if necessary, until it is translucent and lightly browned. Add the spice paste. Stir and fry it for about 1 minute.
- Now put in the fish in a single layer as well as 1 cup of water. Lay the green chillies over the fish.
- Simmer over a medium heat for 2 minutes, spooning the sauce over the fish pieces as you do so. Now cover, turn the heat to low and cook the fish for 10-15 minutes or until it is just done.
- Serve machher jhol (fish in bengali sauce)with rice.
0 comments:
Post a Comment